AT42QT1010 Capacitive Touch Sensor Board

You can add single touch push-button to your project by using this sensor without a need of microprocessor.

When a capacitive load is detected (for example, touching with fingers), LED that is on the board will light up and OUT pin logic level will reach to 1 logic level. An LED circuit on the card can be cancelled by cutting off line when it is not wanted to use. Through to "Mode" solder jumper, transition can done between sensitive mode (it needs approximately 0.5 mA current) or low power consumption (approximately 50 uA).

Technical Features:

• Dimensions: 20 mm x 28 mm
• Weigth: 1.87 gr

Datasheet