It is Desingned 2 Banebots Wheel, 2 Force-Up motor and 2 Ball caster Wheel to Reach Maximum and Ultra Fast. Speed is 9.7 Meters / second.
General Specifications of Kit parts
LineZade Line Follwoer Robot Board: Is Arduino Nano Based. Inrush Current is 4 Amperes. Voltage range is 7v - 45v. This shield has Over Current protection, Lowvoltage protection and overheat protection. This module has start module onboard. You can start by Ir remote controller. Kit gives you oppurtinty bluetooth control. You can buy Bluetooth module.
You can control and drive your robot by mobile phone and tablet. Also you can change PID, maximum speed, average speed on mobile phone, tablet or smart device. And you save time. Development board of cheetah is arduino nano 328.
6V 6000 Rpm Force-Up Dc Motor: Force-Up motors gives you high speed and ultra torque
QTR-8A Infrared Sensor: This sensor module has 8 IR LED/phototransistor pairs mounted on a 0.375" pitch, making it a great detector for a line-following robot. Pairs of LEDs are arranged in series to halve current consumption, and a MOSFET allows the LEDs to be turned off for additional sensing or power-savings options. Each sensor provides a separate Analog I/O-measurable output.
Banebots Wheels: Wheel tread composed of shore A30 allows you reach highest speed.
• Software(program ) is free and will be sent with arduino nano.
• You can buy kit assembled or unassembled.
• Assembly guide and documentions will be send in kit.
Cheetah Fast Line Following Robot Kit Material List is Below;
1 x Linezade Line Following Robot Board
2 x 6V 6000 Rpm Force-Up Dc Motor
1 x QTR-8A Infrared Sensor - Analog
2 Pieces x BaneBots Wheel 41x10mm
2 Pieces x BaneBots Single Hub
1 x MZ80 Object Sensor 80Cm.
1 x MZ80 Sensor Apparatus
2 x 12mm Motor Holder Apparatus
2 Pieces x Plastic Ball cater wheel
1 Pieces x Cheetah Fast Line Following Robot Body
1 x 11.1Volt 500mAh Lipo Battery
1 x 20 Female to Female Jumper Cable Set
1 Set x (Nuts for Installation + Bolt + Cable)